Infinity Chimp 300 - Remove Fixture(S) from a Group Using Group Split Widget; Remove Fixture(S) from a Group Using the Commandline Interface; Replace (Overwrite) a Group; Replace Fixture(S) from a Group Using Group Split Widget

113
Infinity Chimp Series
Infinity Chimp Series
Alternatively, you can also press [Infinity] while pressing [Rec] to cycle through the different record
modes. To select Remove using this method, you need to press the [Rec] key twice while holding down
[Infinity].
Remove Fixture(s) from a Group using Group Split Widget
● Select the fixtures you would like to remove.
● Open a Group Split Widget by clicking on the Groups button in one of the side menus.
● Hit the [Rec] key on the consoles frontpanel.
● Select the Group you would like to remove the selected fixtures from.
● If you did not select an option from the Record-Toolbar, a dialog window asking you what to do will
open.
● Click on Remove.
Remove Fixture(s) from a Group using the Commandline Interface
● Select the fixtures you would like to remove.
● Press the [Rec] key, followed by the [Group] key.
● Now type the number of the group you would like to remove the Fixtures from on the console’s
keypad, in example, [1] followed by [Enter]
● If you did not select an option from the Record-Toolbar, a dialog window asking you what to do will
open.
● Click on Remove.
Replace (overwrite) a Group
Replace will overwrite an entire group.
The confirmation dialog may be omitted by selecting the Replace option from the record toolbar after
pressing record.
Alternatively, you can also press [Infinity] while pressing [Rec] to cycle through the different record
modes. To select Replace using this method, you need to press the [Rec] key three times while holding
down [Infinity].
Replace Fixture(s) from a Group using Group Split Widget
● Select the fixtures you would like to be in the group.
● Open a Group Split Widget by clicking on the Groups button in one of the side menus.
● Hit the [Rec] key on the consoles frontpanel.
● Select the Group in the Group Pool.
● If you did not select an option from the Record-Toolbar, a dialog window asking you what to do will
open.
● Click on Replace.
Replace Fixture(s) from Group using the Commandline Interface
● Select the fixtures you would like to be in the group.
● Press the [Rec] key, followed by the [Group] key.
● Now type the number of the group on the console’s keypad, in example, [1] followed by [Enter]
● If you did not select an option from the Record-Toolbar, a dialog window asking you what to do will
open.
● Click on Replace.