Infinity Chimp 300 - Merging Contents into a Preset (Or: Updating a Preset); Removing Contents from a Preset; Replacing a Preset

164
Infinity Chimp Series
Infinity Chimp Series
Merging contents into a Preset (Or: Updating a Preset)
In case you wish to update a preset to just adjust some values, in example for a preset that is containing
the position of the lead singer of the show you tour with, the “merge” function is what you are looking for.
● Change the fixture values to your needs
● Press the [Rec] key
● Select the preset you would like to update from the Split Widget or using the command line
interface, i.e. Preset 1.
● A window asking you what to do will be opened. Select Merge to update the presets content with
the touched attributes.
Alternatively, you may also select Merge from the Record toolbar after hitting the [Rec] Key.
Or you can press and hold [Infinity] while pressing [Rec] to cycle through the different record
modes. To select Merge using this method, you need to press the [Rec] key three times while holding
down [Infinity].
Removing Contents from a Preset
Sometimes it is necessary to remove unwanted content from a Preset
● Touch the attributes you would like to remove from a previously stored preset
● Press the [Rec] key.
● Select the preset you would like to remove values from within the preset split widget or using the
command line interface, in example Preset 1.
● A window asking you what to do will be opened. Select Remove to remove touched attributes from
the preset.
Alternatively, you may also select Remove from the Record toolbar after hitting the [Rec] Key.
Or you can press and hold [Infinity] while pressing [Rec] to cycle through the different record
modes. To select Remove using this method, you need to press the [Rec] key twice times while holding
down [Infinity].
Replacing a Preset
Sometimes it may be more convenient to replace a Preset than merging and removing attributes.
Replacing a preset may break cue references, and hence may break cues that have been already
programmed with this preset.
● Change the fixture values
● Press the [Rec] key.
● Select the preset you would like to replace within the preset widget or using the command line
interface, i.e. Preset 1.
● A window asking you what to do will be opened. Select Replace to replace the entire presets
content with the touched attributes in the programmer.