Infinity Chimp 300 - Removing Content from a Cue; Remove Content from a Cue Using the User Interface; Remove Content from a Cue Using the Command Line; Replacing a Cue

176
Infinity Chimp Series
Infinity Chimp Series
Removing content from a Cue
Make sure the the Remove option from the record toolbar after pressing [Rec] is selected.
Alternatively, you can also press [Infinity] while pressing [Rec] to cycle through the different record
modes.
Remove content from a Cue using the User Interface
● Touch the attributes you would like to remove
● Press the [Rec] key
● Make sure the the Remove option from the record toolbar is selected.
● If the cuelist only contains one Cue, the action will be executed right away. If the Cuelist contains
more than one Cue a window will be opened asking you to select the Cue you would like to remove
the Information from.
● Click on Remove after selecting the appropriate Cue.
Remove content from a Cue using the Command Line
● Touch the attributes you would like to remove
● Press the [Rec] key
● Make sure the the Remove option from the record toolbar is selected.
● Press the [Cuelist] key.
● Type the number of the cuelist you would like to update a cue from to - i.e., [1].
● Press the [Cue] key.
● Type the number of the cue you would like to update - i.e., [1].
● Press [Enter] to execute the command.
If the cuelist is selected, you can simply:
● Touch the attributes you would like to remove
● Press the [Rec] key
● Make sure the the Remove option from the record toolbar is selected.
● Type the number of the cue you would like to update - i.e., [1].
● Press [Enter] to execute the command.
Replacing a Cue
Make sure the the Replace option from the record toolbar after pressing [Rec] is selected.
Alternatively, you can also press [Infinity] while pressing [Rec] to cycle through the different record
modes.
Replace content from a Cue using the User Interface
● Touch the attributes you would like to replace
● Press the [Rec] key
● Make sure the the Replace option from the record toolbar is selected.
● If the cuelist only contains one Cue, the action will be executed right away. If the Cuelist contains
more than one Cue a window will be opened asking you to select the Cue you would like to replace
the Information from.
● Click on Replace after selecting the appropriate Cue.
Replace content from a Cue using the Command Line
● Touch the attributes you would like to replace
● Press the [Rec] key
● Make sure the the Replace option from the record toolbar is selected.