Infinity Chimp 300 - Emptying the Programmers Content

121
Infinity Chimp Series
Infinity Chimp Series
Emptying the Programmers „Content“
For all playbacks to re-gain control over the fixture attributes contained in the programmer, the
programmer needs to be cleared.
This happens in three steps with each press of the [Clear] key.
The first press of the [Clear] key will un-touch all values, however they are still in the programmer
overriding the playback.
The second press of the [Clear] button will remove all values from the programmer and playback
values will be output again.
The third and last press will unselect all fixtures that were selected.
In short, three times [Clear] will clear the programmer:
[Clear] [Clear] [Clear]
If you accidentally cleared the programmer contents, [Infinity] + [Clear] will undo the last clear
command.
You can also push and hold the [Clear] button for a short moment to clear the programmer
completely.