259
Basic Cleaning Instructions
The screen of the device should be cleaned periodically. The cleaning schedule depends on the
conditions at the site where the device is installed. When smoke or fog machines are used at the site, the
device will need more frequent cleaning. On the other hand, if the device is installed in well-ventilated
area, it will need less frequent cleaning. To establish a cleaning schedule, examine the device at regular
intervals during the first 100 hours of operation.
To clean the device, follow the steps below:
Disconnect the device from the electrical power supply.
Allow the device to cool down for at least 15 minutes.
Remove the dust collected on the external surface with dry compressed air and a soft brush.
Clean the screens with a damp cloth. Use a mild detergent solution.
Dry the screens carefully with a lint-free cloth.
Clean the DMX and other connections with a damp cloth.
Attention
● Do not immerse the device in liquid.
● Do not use alcohol or solvents.
● Make sure that the connections are fully dry before connecting the device to the power supply and
to other devices.
Corrective Maintenance
The device does not contain user-serviceable parts. Do not open the device and do not modify the
device.
Refer repairs and servicing to instructed or skilled persons. Contact your Highlite International dealer for
more information.
To Next Page
Loading...
