175
Updating Cues in a Cuelist
Sometimes it is necessary to update previously recorded cues by adding (merging) or removing content.
Remember, only values that are touched and active will be recorded.
Updating / Mergin data into a Cue
Make sure the the Merge option from the record toolbar after pressing [Rec] is selected.
Alternatively, you can also press [Infinity] while pressing [Rec] to cycle through the different record
modes.
Merge / Add content to a Cue using the User Interface
● Set the values you would like to change
● Press the [Rec] key
● Make sure the the Merge option from the record toolbar is selected.
● If the cuelist only contains one Cue, the action will be executed right away. If the Cuelist contains
more than one Cue a window will be opened asking you to select the Cue you would like to update.
● Click on Merge after selecting the appropriate Cue.
Merge data into a cue using the commandline
● Set the values you would like to change
● Press the [Rec] key
● Make sure the the Merge option from the record toolbar is selected.
● Press the [Cuelist] key.
● Type the number of the cuelist you would like to update a cue from to - i.e., [1].
● Press the [Cue] key.
● Type the number of the cue you would like to update - i.e., [1].
● Press [Enter] to execute the command.
If the cuelist is selected, you can simply:
● Set the values you would like to change
● Press the [Rec] key
● Make sure the the Merge option from the record toolbar is selected.
● Type the number of the cue you would like to update - i.e., [1].
● Press [Enter] to execute the command.
To Next Page
Loading...
