29
Starting multiple Cuelists with different priorities
Lets take our previous example and add different priorities to the mix:
#1: Intensity 80%
#2: Intensity and Color High 50% Red
The next table will show you what the results would be:
Dimmer Color Gobo
80% Red Gobo 1
As you can see, the „High Priority“ option is only affecting LTP channels.
Stopping Cuelists with different priorities
Lets take our previous example again and switch off one of the cuelists after starting them all:
Cuelist (In start order) Priority Dimmer Color Gobo
#1: Intensity 80%
#2: Intensity and Color High 50% Red
#3: Gobo High Gobo 1
#4: Gobo and Color Blue Gobo 2
Will genereate the following output:
Dimmer Color Gobo
80% Red Gobo 1
After stopping Cuelist #2, the following values are output:
Dimmer Color Gobo
80% Blue Gobo 1
To Next Page
Loading...
