133
Dimmer Levels may easily be fanned using the below syntax. Keypad fanning will also take grouping into
account.
Make sure you have made your fixture selection before entering any of the commands below. Press the
[Enter] key to execute each command:
[Value A] [Thru] [Value B]
Will fan the Intensity for selected fixtures from [Value
A] to [Value B]
In Example:
[0] [Thru] [100] with 3 selected fixtures will set
fixture 1 to 0%, fixture 2 to 50% and fixture 3 to 100%.
[Value A] [Thru] [Thru]
[Value B]
Will fan the Intensity for selected fixtures from [Value
A] to [Value B] and back to [Value A].
In Example:
[0] [Thru] [Thru] [100] with 5 selected fixtures
will set fixture 1 and 5 to 0%, fixture 2 and 4 to 50%
and fixture 3 to 100%.
To Next Page
Loading...
