Inovance IS810N-INT Series - Page 209

IS810N-INT Series Servo System User Manual (Brief)Chapter 6 Commissioning Software
- 209 -
2.2.2. Motion Control Axis Settings
Perform detailed congurations for the axis parameters: All the four axes under each slave
need to be congured using the same conguration process. If the number of axes is less
than 2, set the value of 0200 of the IS810 servo drive to
255
to shield the axis; for any axis
in normal use, perform normal congurations. The following example shows how to congure
one of the axes.
2.2.3. Variable Congurations for Servo Axis Communication Mapping
Click
Detailed Settings
to expand the conguration parameters. Perform object mapping
congurations completely based on the following table and carefully check them. Currently,
all IS810N axis congurations must be performed manually due to the limitation on Omron
backend congurations.