Inovance IS810N-INT Series - Precautions

IS810N-INT Series Servo System User Manual (Brief)
- 3 -
Preface
Precautions
u
This product is a general industrial product, and is not designed for use in machinery or
systems on which lives depend.
u
Wiring, operation, maintenance, and inspection of the product can only be conducted by
a qualied person.
u
When selecting the screw tightening torque, consider the strength of the screw and
material of the installation part. Select a proper torque to tightly fasten a screw without
damaging the installation part.
u
Install a correct safety device when this product is to be used on machinery which may
cause a serious accident or loss due to failures of the product.
u
Contact Inovance when this product is to be used for atomic energy control, aerospace
equipment, transport equipment, medical appliances, safety devices, or other equipment
that require high cleanliness.
u
Although this product has passed all QC tests, it may react unexpectedly due to faults
arising from ambient noise, static electricity, input power supply, wiring, parts, and so
on. Take mechanical safety measures into full consideration to ensure safety in the
application site where all possible actions of the equipment occur.
u
When the motor shaft rotates without being grounded, the motor bearing may suffer from
electric corrosion or emit louder noise based on the actual mechanical and installation
conditions. Check the problem yourself.
u
Faults of this product may cause smoke. Pay special attention to such conditions when
the product is used in a purication workshop or other similar environments.
u
Chip resistor disconnection or poor contact may occur due to a sulfuration reaction if the
product is used in an environment with dense sulphur or sulfuretted gas.
u
Inputting a voltage far stronger than the rated voltage may cause damages to the internal
components, thus resulting in smoke or a re.
u
End users shall decide whether the servo drive matches the structure, size, service life,
features, specication change of the equipment where the servo drive is to be installed
and its parts, and whether it complies with local laws and regulations.
u
Note that use of this product beyond its specications is not guaranteed.
u
Some components of this product may be subject to change as we are dedicated to
continuous improvement of the product.
Change History
Date Version Description
July 2017 A00 First release