Inovance IS810N-INT Series - Approvals

IS810N-INT Series Servo System User Manual (Brief)
- 4 -
Preface
§ Approvals
Certication marks on the product nameplate indicate compliance with the corresponding
certicates and standards.
Certication
Mark
Directives Standard
CE
EMC
directives
2014/30/EU
AC servo drive EN 61800-3
AC servo motor EN 60034-1
LVD directives 2014/35/EU
AC servo drive EN61800-5-1
AC servo motor EN 60034-1
RoHS
directives
2011/65/EU EN 50581
TUV -
AC servo drive EN61800-5-1
AC servo motor EN 60034-1
Note:
u
The preceding EMC directives are complied with only when the EMC electric installation
requirements are strictly observed.
u
Machines and devices used together with this drive must also be CE certied and
marked. The integrator who integrates the drive with the CE mark into other devices
has the responsibility to ensure CE standard compliance and verify that conditions
meet European standards. The installer of the drive is responsible for complying with all
relevant regulations on wiring, circuit fuse protection, earthing, accident prevention and
electromagnetic (EMC regulations). In particular, fault discrimination for preventing re
risks and solid earthing practices must be adhered to for electrical safety (also for good
EMC practice).
u
For more information about certication, consult our distributor or sales representative.