Assembly
Supplement: CUSA Excel Ultrasonic Surgical Aspirator System User’s Guide S-5
Assembly
For this procedure, use the sterile, disposable torque wrench (C5601 for
23 kHz or C5602 for 36 kHz) and the sterilizable torque base (C5623 for
23 kHz or C5636 for 36 kHz).
Attach the Tip and O-rings
1. Thread the tip of choice
onto the handpiece
connecting body. Turn
the tip until it is finger
tight.
2. The sterilized torque base should be in the sterilizer tray. Verify that
the handpiece support color on the torque base matches the color on
the handpiece connector (23 kHz – green; 36 kHz – blue). Remove the
sterilized torque base from the sterilizer tray.
3. Put the handpiece in the
torque base so that the
metal connecting body
fits snugly in the metal
slot at the end of the
support.
Warning
If you are changing tips on the sterile field, do not attach any tip or nosecone to
the handpiece before sterilizing it. Patient injury may result.
Before use, sterilize the sterilizable torque base in the sterilizer tray with the
handpiece.
Connecting
body
To Next Page
Loading...
Need help?
General
