IRIS iQ 200 Sprint

Iris Diagnostics, a Division of Iris International, Inc.
iQ
®
200 Sprint™ (2G) Automated Urine Microscopy Analyzer Service Manual 300-4949 Rev A 01/2005 6-1
6. Troubleshooting
6
Troubleshooting
Bypassing Error Condition .............................................................................................6-2
Decoding the Valves field in Valve Error Reports.......................................................6-2
Iris Diagnostics Contact Information ..............................................................................6-2
Troubleshooting Guide...................................................................................................6-3
System locked up .......................................................................................................6-3
Autofocus failed..........................................................................................................6-3
IQ 200 fails to go to Standby ......................................................................................6-4
ID errors......................................................................................................................6-4
Sequential flag errors .................................................................................................6-5
Valve failure to open or close .....................................................................................6-5
System does not go into Standby mode.....................................................................6-5
Samples take more than 60 secs to process and complete .......................................6-5
Positive control failure ................................................................................................6-5
Calibration rack failed.................................................................................................6-6
Non uniform flow in Runfile.........................................................................................6-6
Inconsistent cell count from run to run in Runfile........................................................6-6
SP-FLI (spatial flow index) is high in all Runfiles........................................................6-6
SP-KSP are high in all Runfiles ..................................................................................6-6
Bubbles are present in fluid system............................................................................6-6
Waste well overflow....................................................................................................6-7
Event Log Error Messages .........................................................................................6-7