IRIS iQ 200 Sprint

Iris Diagnostics, a Division of Iris International, Inc.
iQ
®
200 Sprint™ (2G) Automated Urine Microscopy Analyzer Service Manual 300-4949 Rev A 01/2005 9-1
9. Preventive Maintenance
9
Preventive
Maintenance
iQ
®
200 Preventive Maintenance Procedure...................................................................9-2
Surface clean-up ........................................................................................................9-3
Fluidic system flush ....................................................................................................9-3
Rinse/Waste Well Clean Up .......................................................................................9-4
Fluidic system components replacement ...................................................................9-5
Peristaltic pump cassettes replacement.....................................................................9-5
Tubing replacement....................................................................................................9-7
Adjustment verification .............................................................................................9-11
Sampler Calibration ..................................................................................................9-11
Tube detector verification .........................................................................................9-11
Barcode scanner alignment verification....................................................................9-11
SPA alignment verification........................................................................................9-12
Fluidic system inspection..........................................................................................9-12
Auto-Focus run .........................................................................................................9-13
Optical Bench Verification ........................................................................................9-12
Performance verification...........................................................................................9-13
Calibration run ..........................................................................................................9-13
Control run................................................................................................................9-13
Reporting..................................................................................................................9-13