IRIS iQ 200 Sprint

Iris Diagnostics, a Division of Iris International, Inc.
iQ
®
200 Sprint™ (2G) Automated Urine Microscopy Analyzer Service Manual 300-4949 Rev A 01/2005 6
Table of Contents
Sensors ............................................................................................................5-18
FBA ..................................................................................................................5-18
Pumps/Sheath pump/Sensors..........................................................................5-18
Pumps/Cannula pump/Sensors........................................................................5-18
Program Operation...........................................................................................5-19
Frequently Asked Questions (FAQ) .................................................................5-19
Why Does a Sensor Display the Wrong Value?...............................................5-19
Which Controller Does Component X (Pump, Valve, etc.) Belong To? ...........5-19
What Are the Communication Addresses of the Major System Components? 5-20
What Should I Do If the Service Application Appears to Hang?.......................5-20
Service Tree .....................................................................................................5-21
Master ..............................................................................................................5-21
SPA Motors ......................................................................................................5-22
SPA Pumps and Valves ...................................................................................5-23
FBA Pumps and Sequences ............................................................................5-25
STM Motors 1...................................................................................................5-26
STM Motors 2, Sensors, Calibration Table and Sequences ............................5-27
OBA..................................................................................................................5-28
Versions 1 ........................................................................................................5-29
Versions 2 ........................................................................................................5-30
6 - Troubleshooting
Bypassing Error Condition..................................................................................6-2
Decoding the Valves field in Valve Error Reports ..............................................6-2
Iris Diagnostics Contact Information...................................................................6-2
Troubleshooting Guide .......................................................................................6-3
System locked up ...............................................................................................6-3
Autofocus failed..................................................................................................6-3
IQ 200 fails to go to Standby ..............................................................................6-4
ID errors .............................................................................................................6-4
Illumination/Sequential errors.............................................................................6-5
Valve failure to open or close .............................................................................6-5
System does not go into Standby mode.............................................................6-5
Samples take more than 60 secs to process and complete...............................6-5
Positive control failure ........................................................................................6-5
Calibration rack failed.........................................................................................6-5
Non uniform flow in Runfile ................................................................................6-6
Inconsistent cell count from run to run in Runfile ...............................................6-6
SP-FLI (spatial flow index) is high in all Runfiles................................................6-6
SP-KSP are high in all Runfiles..........................................................................6-6
Bubbles are present in fluid system ...................................................................6-6
Waste well overflow............................................................................................6-6
Event Log Error Messages.................................................................................6-7