3 Basic Operation of ECDIS 3-52
3.3.9.8 Panel Display of AIS/TT Target
Left-click on the AIS/TT target displayed on the screen so that AIS/TT information will be on the
“Select List” panel on the display panel.
1) Or right-click on the chart, then select [TGT Data] from the context menu.
The cross cursor becomes the box cursor.
2) Use the trackball to move the cursor to the AIS/TT target, and then left-click.
The “Selected List” panel will open and AIS/TT target information will be displayed.
In the normal menu
Select [MENU] - [(1) AIS/TT] - [(7) Select List] in that order.
In the Table Editing menu, Graphic Editing menu, User Chart Editing menu
Select [MENU] - [(3) AIS/TT] - [(7) Select List] in that order.
If you wish to have the “Selected List” panel open in advance,
- Up to 3 targets can be simultaneously displayed on the “Selected Target” panel. The target that was
selected first is displayed in the top panel. As new targets are selected and displayed, previous targets
move down by one. When the fourth target is selected, the bottom target display panel will no longer
display the first target selection.
- To delete a panel display, left-click on the [Release] provided in each panel. As other way, select
[Cancel TGT Data] on the
context menu and left-click the target. If there is a target below the deleted
target, it moves up by one.
Bearing:
Bearing towards the AIS/TT target
Status:
Current status of the AIS/TT target
Position:
Current position of the AIS/TT target
Name:
Name of the AIS target (not
displayed for TT targets)
TCPA:
Time to closest point of approach
to the AIS target
CPA:
Closest point of approach to the AIS
target
SOG:
S
To Next Page
Loading...
