JRC JAN-701B - Operation Flowchart for Table Editor

4 Route Planning
4-14
In the normal menu, select [MENU] - [(2) Route] - [(1) RoutePlanning] - [(1) Table
Editor] in that order.
Open a new route file.
W000 entry screen
The following items are automatically
displayed. Change, if necessary.
• XTL(PORT/STBD)
• ARR RAD
• SPD[kn]
• Sail (RL/GC)
• Time Zone
• Name
Exit the Table Editing mode.
4.1.2.3 Operation Flowchart for Table Editor
The following shows the general flowchart for planning a route using the Table Editor.
File opening and saving operation differs depending on whether you make a new route file or you select a
route file previously made, though the table editing operation is the same.
(1) Making a new route file (Table Editor)
Start
Clear any route if
dis
p
la
y
ed.
Enter the Table
Editing mode.
Left-click [New].
.
W000 entry
Position (Lat./Lon.)
Left-click the next
WPT No.
W001 entry
Position (Lat./Lon.)
Repeat WPT entry
until the final WPT.
Left-click [Save]
Enter the file name.
Left-click [Close]
End
Table editing operation
Left-click to select [UNLOAD].