3 Basic Operation of ECDIS 3-119
ECDIS
3.18.2 Marking the Information Mark
You can put an Information Mark ( ) at any point on the chart.
1) In the normal menu
Select [MENU] - [(6) Chart] - [(1) Marking/Highlighting] - [(2) Information Mark] in that order.
In the Table Editing menu, Graphic Editing menu
Select [MENU] - [(5) Chart] - [(1) Marking/Highlighting] - [(2) Information Mark] in that order.
In the User Chart Editing menu
Select [MENU] - [(4) Chart] - [(1) Marking/Highlighting] - [(2) Information Mark] in that order.
The “Location/Attributes - Information” panel opens and the cross cursor changes to the
cursor.
2) Rotate the trackball and move the cursor to the point you want and left-click at that position.
The left-clicked position is displayed in the position box of the panel.
3) In the “Location/Attributes - Information” panel, perform the following editing operation.
• Enter the comment on the Information Mark.
• You can edit the minimum scale and maximum scale that limit the display of the Information
Mark.
• To edit the Information Mark position, left-click each column of LAT/LON.
The latitude and longitude entry panel opens.
Enter the value and left-click the [OK] .
• To fix the contents and close the panel, left-click the [OK] .
You will see that the Information Mark (
) is put on the screen.
[Apply]: It is possible to do setting in the valid without closing a panel.
• For viewing the Information on the Information Mark or editing/deleting the Information Mark,
see 3.14“Reading Out Information on the Objects”.
Position of the Information
Information Mark
To Next Page
Loading...
