JRC JAN-701B - Changing the Base Point of EBL;VRM

3 Basic Operation of ECDIS 3-112
3.15.3.3 Changing the base point of EBL/VRM
The following description is an operation to change the base of EBL1/VRM1.
EBL2/VRM2 becomes a similar operation.
(1) Changing Dropped (the base position is floating).
1) When “Base point button” is displayed blank
, left-click to this button.
Then, “Base point button” is changed to display “D” and EBL1 is displayed.
At the same time, the base point of EBL1 is displayed on the cursor.
2) Move the cursor and left-click at the position you want. Then, the base point is fixed.
(2) Changing CCRP (the base position is ship-centered).
1) When “Base point button” is displayed “D”
, left-click to this button.
Then, “Base point button” is changed to display blank and EBL1 is displayed.
At the same time, the base point of EBL1 is displayed on the ship.
Lift-click to the “Base point button”