5 Chart Editing
5-14
5.3.2.2 Editing a User Map
Follow the procedure below to edit an existing user map.
(1) Starting User Map Editing mode
1) In the normal menu
Select [MENU] - [(5) User Map] - [(3) User Map Editor] in that order.
(2) Opening a user map file
1) Left-click on the [Open] button.
In the User Map Editing menu
Select [MENU] - [(1) File] - [(2) Open] in that order.
The “Open Chart File” panel will be displayed.
2) Select the name of a file you wish to open, and then left-click on the [OK] button.
The selected user map file will be displayed.
(3) Entering objects
1) When you use EBL/VRM to enter objects, make sure that [(4) Use EBL/VRM] is turned on
(checked). If you do not use EBL/VRM when editing a map,
In the User Chart Editing menu
Select [MENU] - [(2) Edit] - [(4) Use EBL/VRM] in that order.
[(4) Use EBL/VRM] is turned off (remove a checkmark).
2) Proceed to 5.5 “Entering Objects” and enter objects.
• After obtaining objects, follow the procedure described in (4) below to save a user map file.
If using EBL/VRM: Check it.
If not using EBL/VRM: Uncheck it.
To Next Page
Loading...
