JRC JAN-701B - Displaying the Chart by Entering the Position

3 Basic Operation of ECDIS 3-59
ECDIS
(2) Menu operation to jump to the port
In the normal menu
Select [MENU] - [(6) Chart] - [(3)User Setting] - [(2) My Port List] in that order.
In the Table Editing menu, Graphic Editing menu
Select [MENU] - [(5) Chart] - [(3)User Setting] - [(2) My Port List] in that order.
In the User Chart Editing menu
Select [MENU] - [(4) Chart] - [(3)User Setting] - [(2) My Port List] in that order.
The “My Port List” panel opens, where position and scale column are shown.
- To jump to the port, left-click a port name then the [Jump] button.
- To delete the registered port, left-click a port name then the [Delete] .
- To close the panel, left-click the [Close] .
3.4.5 Displaying the Chart by Entering the
Position
You can see the chart to the position you want by entering the position in the position entry panel.
You can operate from the menu only.
• To return to the original chart where your ship is, press the [HOME] .
1) In the normal menu
Select [MENU] - [(6) Chart] - [(2) Off Center] - [(1) Enter Position] in that order.
In the Table Editing menu, Graphic Editing menu
Select [MENU] - [(5) Chart] - [(2) Off Center] - [(1) Enter Position] in that order.
In the User Chart Editing menu
Select [MENU] - [(4) Chart] - [(2) Off Center] - [(1) Enter Position] in that order.
The “Enter Position” panel opens.
2) Enter the position (latitude and longitude), and left-click the
[OK] .
The panel closes and the chart will be displayed to the
designated position.