JRC JAN-701B - Creating a Route Using EBL;VRM Keys and Dials

4 Route Planning
4-59
ECDIS
(1) Alternate Route Editing mode
In the normal menu
Select [MENU] - [(2) Route] - [(2) Create Alternate Route] in that order.
The Alternate Route Editing screen as shown below will open. (This screen is the same as for
Graphic Editor.)
[Alternate Route Editing Screen]
Opening the Alternate Route Editing Menu:
On the display panel in the Alternate Route Editing mode
Rotate the trackball to move the cursor on upper part of screen.
The special menu for Alternate Route Editor will open. (This menu is the same as for Graphic
Editor.)
(2) Creating Alternate Route
The following shows the way how to make an alternate route using the buttons on the screens.
(When you use the EBL/VRM on the operation panel, see 4.1.3.8 “Creating a Route Using
EBL/VRM Keys and Dials”.
Operate while watching the cursor position displayed at the bottom of the display panel.
Note:
• Alternate routes will be displayed in orange so that the modified section can be differentiated from
the original route.