JRC JAN-701B - Setting the View Common Tab

3 Basic Operation of ECDIS 3-160
3.28.1.1 Setting the "View Common" tab
The settings made here apply to “View1” and “View2” tabs for single/multi-view.
1) Left-click the item to Select.[OK] on the panel to close it.
a) Display Category (S-57/C-MAP Only)
• Base/Standard/Other
Selection is the same as when the [Base], [Standard] and [Other] on the display panel are
used. For detailed function, see 3.6 “Changing the Object Category (S-57/C-MAP Only)”.
b) Area Boundary (S-57/C-MAP Only)
• Plane : Plane boundary (The boundary of the area is drawn by the dotted lines)
• Symbolized : Symbolized boundary (The boundary of the area is drawn by the symbolized
line)
Boundary of the area
Boundary of the area