JRC JAN-701B - Operation When Manually Updating Objects

5 Chart Editing
5-20
5.4.2 Operation when Manually Updating Objects
This section describes operations in the manual update procedure (descriptions follow 5.4.1 “Flow of
Manual Update”).
Note:
The maximum of the object is 20,000. (On "Polygon" object, "Warning Area" object and Line Object
except for "Arc", it counts 1 top as one.) When adding beyond 20,000, the "Max Point" notice occurs
and it isn't possible to do the addition of the object.
(1) Starting Manual Update mode
1) In the normal menu
Select [MENU] - [(6) Chart] - [(8) Manual UpDate] in that order.
- Left-click on the [MENU] button on the display panel to open the Chart Edit menu.
The Chart Edit menu will be displayed at the top of the screen. Left-click on the [MENU] button
again or left-click anywhere on the chart to close the menu window.
[Chart Edit menu]
(2) Selecting a chart to be edited
1) Left-click on the [Start] button.
The “Information” panel will be displayed. Left-click on the [OK] button so that the panel
closes.
2) Left-click on the chart you wish to edit.
A panel showing the chart name will be displayed. Left-click on the [OK] button so that the
panel closes (as shown below).
Note:
When you click the [Start] button in the editing, the following operation is done.
・ When not editing, the new operation becomes beginning.
・ When editing, confirmation dialog "Save Change to ****?" is displayed.
“Yes”: It shifts to the save operation.
“No”: It cancels update contents, and new operation
becomes beginning.
“Cancel”: It closes a dialog and returns to edit operation.