6 Automatic Sailing
6-9
ECDIS
6.3.2 Start Automatic Sailing of Normal Route
1) In the normal menu
Select [MENU] - [(3) AUTO Sail] - [(1) Start] in that order.
Then, the “Select WPT” panel opens.
If the following warning is displayed, confirm whether to have selected Normal Route.
2) Left-click the [OK] to close the panel.
Then, the "Confirmation" panel will appear.
Click the [OK] if confirming that there is not a problem in the setting.
When there is a problem in the setting and close the "Confirmation" panel, click the [Cancel].
3) Left-click the [OK] to continue automatic sailing procedure.
Then, the automatic sailing starts and route monitoring is carried out by the system.
During automatic sailing, you should turn the ship with the [TURN] key as follows:
When the ship arrived at the boundary of the WPT, “Arrived at WPT” alarm is issued.
Press the [TURN] key on the operation panel.
Then, the ship will start to turn.
Note:
During automatic sailing, the following menu changes invalidly.
・
[Menu] - [(9)Exit]
・
[Menu] - [(3)AUTO Sail] – [(1)Start]
By terminating automatic sailing, it returns in the validity.
Displays the [Route] file selecting on the display
panel.
Choose "To Waypoint" number displaying
alternative which was set in the [Route] file.
If you want to cancel the operation and close
the panel, click [Cancel].
To fix setting, click [OK].
To Next Page
Loading...
