6 Automatic Sailing
6-2
Before starting automatic sailing, be sure to check the safety of the route
and crossing safety contour.
Otherwise, accidents may result.
When this system is connected to an autopilot, a set course is calculated from the scheduled route and
ship’s position. By outputting the set course to the autopilot, automatic sailing along the scheduled route
is possible.
Note:
• Automatic sailing is not permitted while charts are displayed in multi view mode.
And exiting Navigation & Planning is not permitted during automatic sailing.
6.1 Automatic Sailing System
6.1.1 Change of Course (Turning) of Normal Route
When the ship arrived at the boundary of the WPT, you need to perform the following operation for turning
the ship.
•On the operation panel, press the [TURN] key.
[Turing Operation]
Boundary of WPT
Next Leg
Arrival alarm
Cross track distance (XTD)
To Next Page
Loading...
