6 Automatic Sailing
6-11
ECDIS
3) Left-click the [OK] to close the panel.
If there is no problem in the setting, the "Confirmation" panel will appear.
Click the [OK] if confirming that there is not a problem in the setting.
When there is a problem in the setting and close the "Confirmation" panel, click the [Cancel].
4) Left-click the [OK] to continue automatic sailing procedure.
Then, the automatic sailing starts and route monitoring is carried out by the system.
During automatic sailing, you should turn the ship with the [TURN] key as follows:
When ”Actual Course Change” alarm is occurred 30 seconds before arrived at WOL.
Press the [TURN] key on the operation panel.
Then, the ship will start to turn.
Note:
During automatic sailing, the following menu changes invalidly.
・
[Menu] - [(9)Exit]
・
[Menu] - [(3)AUTO Sail] – [(1)Start]
By terminating automatic sailing, it returns in the validity.
6.3.4 Terminating the Automatic Sailing
1) In the normal menu
Select [MENU] - [(3) AUTO Sail] - [(2) Stop] in that order.
Then, the "Confirmation" panel will appear.
2) Left-click the [OK] to stop the automatic sailing.
When [Cancel] is clicked, Auto Sail is continued.
To Next Page
Loading...
