3 Basic Operation of ECDIS 3-20
3.3 Power ON/OFF and Preparation
How to turn the power ON and OFF and preparation before sailing are described here.
Note that, when you turn the power OFF, you must terminate the system by following the termination
sequence described here.
Also, how to recover the system in case of hung up is explained.
3.3.1 Power ON ([POWER])
On the operation panel
Press the [POWER] key.
The power turns on, and the [POWER] key will light. After a short while, the startup menu will be
displayed.
Do not turn on the power of the equipment with a floppy disk inserted in the
floppy disk drive.
The equipment will not start normally.
[POWER] key
When ON: Lighting
To Next Page
Loading...
