6 Automatic Sailing
6-10
6.3.3 Start Automatic Sailing of TCS Route
1) In the normal menu
Select [MENU] - [(3) AUTO Sail] - [(1) Start] in that order.
Then, the “Select WPT” panel opens.
If the following warning is displayed, confirm whether to have selected TCS route.
If the following warning is displayed, check the Limit and Safety check by Route Planning.
2) Left-click the [OK] to close the panel.
Then, the "Confirmation" panel will appear.
Click the [OK] if confirming that there is not a problem in the setting.
When there is a problem in the setting and close the "Confirmation" panel, click the [Cancel].
Displays the [Route] file
selecting on the display panel.
Choose "To Waypoint" number
displaying alternative which
was set in the [Route] file.
To fix setting, click [OK].
If you want to cancel the operation and close the dialog,
click [Cancel].
Please do not change the
setting as follows:
Pre Run Speed
Pre Run Time
Enter Angle
Turn Radius
Pre Run Distance
XTD MAX
To Next Page
Loading...
