JRC JAN-701B - My Port List

3 Basic Operation of ECDIS 3-71
ECDIS
3.8 My Port List
3.8.1 Adding to My Port List
You can register any position on the chart to the My Port List. After registration, you can directly access
to that position by selecting a port name from the My Port List.
The general registration procedure is as follows:
1) Display the position you want to register to the My Port List.
S-57/C-MAP:
The current position will be registered as it is to the My Port List with the current scale. So,
center the position you want before you register it to the My Port List.
When you want to select another position, shift the chart area (see 3.4 “Shifting the Chart”) and
zoom in/out the chart (see 3.5 “Zooming In/Out the Chart (S-57/C-MAP Only)”) as required.
ARCS:
The current chart position will be registered as it is to the My Port List with the current size. So,
center the position you want before you register it to the My Port List.
When you want to select another chart:
• Select right-click-[Select Chart under Cursor] or [Select Chart] on Display panel in that order.
For details, see 3.10.3 “Selecting Chart under Cursor (ARCS Only)” or 3.10.4 “Selecting
Chart from All (ARCS Only)”.
2) In the normal menu
Select [MENU] - [(6) Chart] - [(3) User Setting] - [(1) Save My Port List] in that order.
In the Table Editing menu, Graphic Editing menu,
Select [MENU] - [(5) Chart] - [(3) User Setting] - [(1) Save My Port List] in that order.
In the Table User Chart Editing menu
Select [MENU] - [(4) Chart] - [(3) User Setting] - [(1) Save My Port List] in that order.
The “Add to my Port List” panel opens.
3) Enter a name you want to register and left-click the [OK] to close the panel.
• Up to 15 characters can be input.
• Select a chart and scale.
• Shift the position you want approximately
at the center of the chart.
Register the position to the My
Port List using the menu.