3 Basic Operation of ECDIS 3-19
ECDIS
Flowchart for Sailing -- Continued
• When the ship crosses a waypoint boundary, there will be an updated next
WPT, and an “Arrived at WPT” alarm occurs.
After confirming the alarm contents, press the [ALARM ACK] key on the
operation panel or the [Alarm Acknowledgement] button on the display
panel to stop the alarm.
When the ship exceeds the boundary of the final destination, "Arrived at
LAST WPT" alarm will occur.
After confirming the alarm contents, press the [ALARM ACK] key on the
operation panel or the [Alarm Acknowledgement] button on the display
panel to stop the alarm.
Select "UNLOAD". Then the route selected disappears from the screen.
Route monitoring
("Arrived at WPT" alarm
occurs when arrived at the
WPT.)
rrived at the final destination
("Arrived at LAST WPT" alarm
occurs.)
Unload the route
It repeats itself until the
ship arrives at the last
WPT before the final
destination.
End of sailing
The sequel from the
pre-page
To Next Page
Loading...
