5 Chart Editing
5-21
ECDIS
(3) Entering Objects
1) When you use EBL/VRM to enter objects, make sure that [(4) Use EBL/VRM] is turned on
(checked). If you do not use EBL/VRM when editing a chart, then turn [(4) Use EBL/VRM] off
(remove a checkmark) by selecting [MENU] - [(2) Edit] - [(4) Use EBL/VRM] in that order.
2) Proceed to 5.5 “Entering Objects” and enter objects.
After obtaining objects, follow the procedure described in (4) below to save a Manual Update
file.
(4) Saving a Manual Update
1) Left-click on the [Save] button.
In the Manual Update Editing menu
Select [MENU] - [(1) File] - [(5) Save] in that order.
The “Datum Conversion” panel opens.
Select [Select Datum] or [Enter Offset] to execute datum conversion or offset entering.
Normally, conversion of geodesic systems is not necessary.
• [Select Datum]:
You can convert an object datum from [Source Datum] to [Destination Datum]. Normally,
conversion of geodesic systems is not necessary.
• [Enter Offset]:
You can specify offset (latitude/longitude) of the object and move the object.
2) Left-click on the [OK] button. The panel closes.
The “Notices to Mariners” panel opens.
Enter “the issue date of a notice to mariners.”
3) Left-click on the [OK] button. The panel closes.
4) Left-click on the [Close] button.
Manual Update mode ends.
If using EBL/VRM: Check it.
If not using EBL/VRM: Uncheck it.
To Next Page
Loading...
