5 Chart Editing
5-13
ECDIS
3) Left-click the [SAVE] button to close the panel.
Then, the “Datum Conversion” panel opens.
Select [Select Datum] or [Enter Offset] to execute datum conversion or offset entering.
• Select Datum:
You can convert an object datum from [Source Datum] to [Destination Datum].
• Enter Offset:
You can give offset to the object by entering the offset value (latitude/longitude).
4) Left-click the [OK] button to close the panel.
5) Left-click the [Close] button.
Then, the system exit the User Map Editing mode.
(5) Exiting the User Map Editing mode
1) Click the [Close] button to exit the mode.
2) When you are not operating in the editing, this editor is closed and changed to normal mode.
3) When you are operating in the editing, the confirmation dialog is displayed.
It changes to the save operation.
(See (4) Saving a user map file)
User Map Editor is closed and
editing contents is canceled.
It returns to the edit-display.
To Next Page
Loading...
