5 Chart Editing
5-12
(3) Entering objects
1) When you use EBL/VRM to enter objects, make sure that [(1) Use EBL/VRM] is turned on
(checked). If you do not use EBL/VRM when editing a map,
In the User Map Editing menu
Select [MENU] - [(2) Edit] - [(4) Use EBL/VRM] in that order.
[(4) Use EBL/VRM] is turned off (remove a checkmark).
2) Proceed to 5.5 “Entering Objects” and enter objects.
• After obtaining objects, follow the procedure described in (4) below to save a user map file.
(4) Saving a user map file
1) Left-click the [Save] button.
In the User Map Editing menu
Select [MENU] - [(1) File] - [(5) Save], [(6) Save as] in that order.
The “Save as” panel opens.
2) Enter the file name (up to 8 characters) and comment.
If using EBL/VRM: Check it.
If not using EBL/VRM: Uncheck it.
To Next Page
Loading...
