3 Basic Operation of ECDIS 3-82
Using the Cursor:
1) In the “Chart Shift” panel, left-click the [by Cursor].
The cursor type changes.
2) Move the cursor and left-click at the first position. Then, move the cursor to draw the orange
line to determine the amount of offset, and left-click the cursor at the second position.
Then, the offset values thus obtained are displayed on the “Chart Shift” panel. (You can edit the
value.)
Note that the cursor position is always displayed at the bottom of the display panel.
3) Left-click the [OK] to close the panel.
The chart will move the specified offset value. The chart offset value display section will be
displayed in blue, and “Chart Shift” will be displayed in Panel of the screen.
Also, the shift amount will be displayed in the display panel.
Orange Line
Cursor
Shift amount
To Next Page
Loading...
