3 Basic Operation of ECDIS 3-102
(4) Changing the EBL/VRM marker base point
The following example describes how to change the base point for EBL1 from your ship’s position
to another position.
VRM1, EBL2 and VRM2 are operated in the same way as EBL1.
1) With the EBL1 push EBL dial Then, the EBL/VRM base point displayed in the own ship
position.
2) Move the cursor with EBL/VRM to the new base point position by rotating the trackball.
3) Left-click at the position you want. The base point is fixed at that position
To Next Page
Loading...
