3 Basic Operation of ECDIS 3-137
ECDIS
2) Change setting method of Acquisition Zone
The procedure for changing the setting is shown about the range of the area of “Acquisition
Zone”.
Change setting method of “Acquisition Zone 1” Setting area *the procedure is same as for “Acquisition
Zone 2” Setting area.
1. Select [Make AZ 1] button. Then [Make AZ 1] button is changed color.
2. [EBL] dial of the operation panel is turned and the angle of "Start Side" is changed. Similarly, [VRM]
dial of the operation panel is turned, and the distance of "Far Edge" is changed.
3. [EBL] dial of the operation panel is pushed short.
4. [EBL] dial of the operation panel is turned and the angle of "End Side" is changed. Similarly, [VRM]
dial of the operation panel is turned, and the distance of "Width" is changed.
5. [EBL] dial of the operation panel is pushed short.
The display of "Make AZ 1" returns to the origin, and "AZ Function of Acquisition Zone 1" is valid.
Start Side
Change by [EBL] Dial of the
operation panel.
Setting range is 000.0° -
359.9°.
Far Edge
Change by [VRM] Dial of the
operation panel.
Width is not change.
Setting range is 0.50NM –
31.50NM.
End Side
Change by [EBL] Dial of the operation
panel.
Setting range is 000.0°- 359.9°.
Width
Change by [VRM] Dial of the operation
panel.
Value of Far Edge changes according
to changing Width.
Setting range is 0.50NM - 31.50NM.
To Next Page
Loading...
