3 Basic Operation of ECDIS 3-151
ECDIS
• Others:
Data will be saved when any other kind of alarm (Startup, Offset Reference Point,etc)
occurs.
• Latest display days:
It displays of the number of days of setting,setting log days.
• [Navtex Setting]:
The “Navtex Setting ” panel opens.
Set the Navtex message filtering conditions by selecting each item on the “Station”,
“Month/Year” and “Message” area. Then, left-click the [OK] to close the panel.
The Navtex messages received from the selected “Station” will be filtered by the condition set
by the “Month/Year” and “Message”, and then they will be saved as the Navtex information for
displaying on the chart.
The following “Navtex mark” will be displayed on the chart according to
the Navtex information.
• Station: You can filter the stations by specifying the first letter of the station name.
For example, if you select the letter “A”, the station name that begins with “A”
will be accepted. If you do not select “Filtering”, Messages of all the stations
will be not accepted
• Month/Year: You can filter the Navtex messages by specifying the month/year.
• Message: You can filter the Navtex messages by specifying the kind of the message.
If you do not select “Filtering”, the navigational warnings will be not accepted.
Note:
• The above Navtex filtering function is provided for message display in Logbook.
The function is not for receiving or recording Navtex messages.
•
The Navtex messages to be received vary depending on the filter setting of the Navtex receiver.
For details, see the Navtex receiver instruction manual
To Next Page
Loading...
