3 Basic Operation of ECDIS 3-189
ECDIS
The priority of display is as follows when AIS Target is more than maximum.
① Numerical display Target
② CPA/TCPA Target
③ Target in AZ
④ Association Target
⑤ Activated Target
⑥ In CPA Limit setting range 1.TCPA sequence 2.CPA sequence 3.Number sequence
⑦ Out of CPA Limit setting range 1.Range sequence 2.Number sequence
It sets the range of Ring.
Minimum: 0.0 NM
Maximum: 120.0 NM(MAX)
It becomes valid when check is ON.
Range which was set in Ring and Sector is
displayed when putting a check.
Filter Mode:
[OFF]: Regardless of the setting range,
AIS Target is displayed.
[Display]: Only AIS in the setting range is
displayed.
[Priority]: When AIS Target is displayed
above the maximum, AIS Target
which is the farthest from the
own ship is not displayed in turn.
It sets the range of Sector.
Minimum: 0.0 °
Maximum: 359.9 °
It becomes valid when check is ON.
To Next Page
Loading...
