3 Basic Operation of ECDIS 3-195
ECDIS
Please set the following items:
Reference Point Mark
• For viewing the information on"Reference Point Mark" or editing/deleting "Reference Point Mark",
see 3.14 “Reading Out Information on the Objects”.
Type of reference positioning
Position to display the reference point:
The position can be modified by left-clicking the select each column of [LAT] or [LON].
MIN Scale: Sets the minimum scale in which the “reference point mark” is displayed.
MAX Scale: Sets the maximum scale in which the “reference point mark” is displayed.
Source:
Selects the type of reference positioning data that is to be displayed
for “Reference Point Mark”.
GPS/DGPS/Decca/Loran/Radar/Astronomical/MFDF/Transit/GNSS/
Line of Position/Visual Bearing LOP’S/Visual Range LOP’S
Time: Displays the time to be displayed for reference point marks.
Plot Type: Select EP/DR.
Comment: Comments for a “reference point mark”
can be input.
OK: “Reference Point Mark” will be displayed in the
specified location, and close this panel.
Cancel: “Reference Point Mark” will be not displayed.
Apply: “Reference Point Mark” will be displayed in
the specified location, and keep this panel
displayed.
Delete: Delete in selected
“Reference Point
Mark”
To Next Page
Loading...
