2 Names and Functions
2-9
ECDIS
Note:
The following item can change setting in menu [Main]-[Sensor].
・ Heading Sensor: It chooses from the connected equipment or manual setting.
・ STW Sensor: It chooses from the connected equipment or manual setting.
・ POSN1 (Primary sensor): It chooses from the connected equipment or Dead Reckoning.
・ POSN2: It isn't reflected in the display panel. POSN2 can set like POSN1, or unused.
・ Date and Time Sensor: It chooses from the connected equipment or manual setting.
・ Time Zone Sensor: It chooses from the connected equipment or manual setting.
The following table shows the relation of the sensor name of the display panel to the sensor setting
by POSN1.
POSN1 Sensor
Setting
Input data Display name on
COG and SOG
Display name on
position
DGPS1 GPS (GPS) GPS1
DGPS1 Differential GPS (GPS) DGPS1
DGPS2 GPS (GPS) GPS2
DGPS2 Differential GPS (GPS) DGPS2
GPS-Compass GPS-Compass (GPS) GPS-C
Loran-C Loran-C (Loran) LORAN-C
DR (Dead Reckoning) (DR) DR
2) CTS / Vector Time / Water Depth
Vector time:
It is displaying time for vector length; Ground-referenced
velocity and Water-referenced velocity.
Vector time can be set on menu [(4)Own Ship/Track] -
[(0)Setting].
CTS (Course to Steer):
It is displayed direction azimuth to be sending to Auto Sailing system.
It is displayed during Automatic Sailing.
Depth:
It displays water depth and the standard position from the Depth sensor.
The kind of the standard position: Transducer, Surface, Keel.
To Next Page
Loading...
