10 Maintenance and Inspection
10-18
Trouble –continued--
Symptom Cause Remedy
ARPA is not displayed. The [ARPA] key is not pressed. Press the [ARPA] key.
The ARPA setting is incorrect. Set the ARPA setting correctly.
The radar is not turned ON. Turn the radar ON.
The connector cable is not
connected to the radar.
Check the connection between
the radar and main unit.
The main unit has
malfunctioned.
Call the JRC sales
representative for repair.
The digital wind direction and air
speedometer are not ON.
Turn the digital wind direction
and air speedometer ON.
Wind direction, wind speed
(digital wind direction and air
speedometer) are not
displayed.
The connector cables are not
connected to the digital wind
direction and air speedometer.
Check the connection between
the digital wind direction and air
speedometer.
The main unit has
malfunctioned.
Call the JRC sales
representative for repair.
UKC is not displayed. The depth sounder is not ON. Turn the depth sounder ON.
The connector cable is not
connected to the depth sounder.
Check the connection between
the depth sounder and the main
unit.
The main unit has
malfunctioned.
Call the JRC sales
representative for repair.
The data logger is not ON. Turn the data logger ON. Engine data from data logger
and weather data are not
displayed.
The connector cable is not
connected to the data logger.
Check the connection between
the main unit and the data
logger.
The main unit has
malfunctioned.
Call the JRC sales
representative for repair.
The initial setup has not been
carried out correctly.
Carry out the initial setup
correctly.
Operation is not carried out
correctly.
Carry out the correct operation
referring to the Instruction
Manual.
The autopilot is not ON. Turn the autopilot ON.
The connector cable is not
connected to the autopilot.
Check the connection between
the autopilot and the main unit.
Automatic sailing is not
possible.
The main unit has
malfunctioned.
Call the JRC sales
representative for repair.
To Next Page
Loading...
