Juniper EX4300 Series

• Stop bits—1
• DCD state—Disregard
There are two ways to connect and congure an EX Series switch: one method is through the console by
using the CLI and the other is by using the J-Web interface.
NOTE: EX2200-24T-4G-DC switches do not support switch connecon and conguraon
through the J-Web interface.
This topic describes the CLI procedure.
NOTE: To run the ezsetup script, the switch must have the factory-default conguraon as the
acve conguraon. If you have congured anything on the switch and want to run ezsetup,
revert to the factory-default conguraon. See
Reverng to the Default Factory Conguraon
for the EX Series Switch
.
To connect and congure the switch from the console by using the CLI:
1. Connect the console port to a laptop or PC by using the RJ-45 to DB-9 serial port adapter. An
Ethernet cable that has an RJ-45 connector at either end and an RJ-45 to DB-9 serial port adapter
are supplied with the switch. If your laptop doesn't have a serial port, use a serial to USB adapter.
For the locaon of the console port on dierent EX Series switches:
• See EX2200 Switches Hardware Overview.
• See EX2300 Switches Hardware Overview .
• See Rear Panel of an EX3200 Switch.
• See Rear Panel of an EX3300 Switch.
• See Rear Panel of an EX3400 Switch .
• See Rear Panel of an EX4200 Switch .
• See "EX4300 Switches Hardware Overview" on page 2
• See Front Panel of an EX4500 Switch.
• See EX4550 Switches Hardware Overview
• See Switch Fabric and Roung Engine (SRE) Module in an EX6200 Switch.
242