Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 User Manual

Facility LOG_PFE
ASP_SFW_IP_PACKET_CHECKSUM_ERROR
System Log Message syslog-prefix error-code: proto protocol-id (protocol-name),
source-interface-nameseparatorsource-address:source-port ->
destination-addressdestination-port, event-type
Description The stateful firewall discarded the packet with the indicated characteristics, because
the packet checksum was incorrect. The discarded packet contained the indicated
information about its protocol (numerical identifier and name), source (logical interface
name, IP address, and port number), and destination (IP address and port number).
Type Event: This message reports an event, not an error
Severity notice
Facility LOG_PFE
ASP_SFW_IP_PACKET_DST_BAD
System Log Message syslog-prefix error-code: proto protocol-id (protocol-name),
source-interface-nameseparatorsource-address:source-port ->
destination-addressdestination-port, event-type
Description The stateful firewall discarded the packet with the indicated characteristics, because
the packet destination address was either a multicast address or was in the range reserved
for experimental use (248.0.0.0 through 255.255.255.254). The discarded packet
contained the indicated information about its protocol (numerical identifier and name),
source (logical interface name, IP address, and port number), and destination (IP address
and port number).
Type Event: This message reports an event, not an error
Severity notice
Facility LOG_PFE
ASP_SFW_IP_PACKET_FRAG_LEN_INV
System Log Message syslog-prefix error-code: proto protocol-id (protocol-name),
source-interface-nameseparatorsource-address:source-port ->
destination-addressdestination-port, event-type
Description The stateful firewall discarded the packet with the indicated characteristics and all
related IP fragments it had previously received, because the length of a fragment was
invalid. The discarded packet contained the indicated information about its protocol
(numerical identifier and name), source (logical interface name, IP address, and port
number), and destination (IP address and port number).
Type Event: This message reports an event, not an error
Severity notice
Facility LOG_PFE
Copyright © 2010, Juniper Networks, Inc.92
Junos 10.3 System Log Messages Reference

Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 Specifications

General

Brand	Juniper
Model	JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010
Category	Software
Language	English