about its protocol (numerical identifier and name), source (logical interface name, IP
address, and port number), and destination (IP address and port number).
Type Event: This message reports an event, not an error
Severity critical
Facility LOG_PFE
ASP_SVC_SET_MAX_FLOWS_EXCEEDED
System Log Message Number of flows (currently current-flows) exceeded configured limit (maximum-value)
count times in previous 60 seconds
Description A flow was not created for a service and service set, because the current number of flows
for all supported services exceeded the limit configured with the 'max-flows' statement
at the [edit services service-set <service-set-name>] hierarchy level. The message
appears once per minute and reports the number of times in the previous 60 seconds
that the system noted the excessive number of flows.
Type Event: This message reports an event, not an error
Severity notice
Facility LOG_PFE
Copyright © 2010, Juniper Networks, Inc.104
Junos 10.3 System Log Messages Reference
To Next Page
Loading...