Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 User Manual

Type Event: This message reports an event, not an error
Severity info
Facility ANY
BOOTPD_CONFIG_ERR
System Log Message Problems with configuration file 'filename', using defaults
Description The boot parameter process (tnp.bootpd) could not read the indicated configuration
file, so it initialized using default settings defined at compile time.
Type Error: An error occurred
Severity error
Facility ANY
Action Correct the configuration file.
BOOTPD_CONF_OPEN
System Log Message Unable to open configuration file 'filename'
Description The boot parameter process (tnp.bootpd) could not open the indicated configuration
file, so it initialized using default settings defined at compile time.
Type Event: This message reports an event, not an error
Severity notice
Facility ANY
Action Contact your technical support representative.
BOOTPD_DUP_PIC_SLOT
System Log Message Duplicate default value defined for PIC pic-slot in FPC fpc-slot
Description As each hardware component on the routing platform initializes, it requests a boot string
from the boot parameter process (tnp.bootpd). The boot strings are defined in the
configuration file for tnp.bootpd. There was more than one definition in the file for the
indicated Physical Interface Card (PIC) slot in the indicated Flexible PIC Concentrator
(FPC), so tnp.bootpd used the first definition it found.
Type Event: This message reports an event, not an error
Severity notice
Facility ANY
Action Remove the extra definitions from the configuration file.
Copyright © 2010, Juniper Networks, Inc.124
Junos 10.3 System Log Messages Reference

Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 Specifications

General

Brand	Juniper
Model	JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010
Category	Software
Language	English