CHASSISD_CB_CLOCK_CHECKSUM
System Log Message Clock module on M120 CB had configuration data checksum error
Description The chassis process (chassisd) detected a checksum error for the clock module on an
M120 Control Board (CB).
Type Error: An error occurred
Severity error
Facility LOG_DAEMON
CHASSISD_CB_MASTER_BP_IGNORED
System Log Message Press of online/offline button ignored for master fru-name fru-slot
Description The online/offline button for the indicated control board was pressed, but the chassis
process (chassisd) ignored the request. The control board for M40e and M160 routers
is the Miscellaneous Control Subsystem (MCS). The control board for M320, T320, and
T640 routing platforms is the Control Board (CB).
Type Event: This message reports an event, not an error
Severity error
Facility LOG_DAEMON
Cause The control board was acting as master.
Action Switch mastership to the other control board before taking the control board offline.
CHASSISD_CB_READ
System Log Message Error reading midplane ID EEPROM, errno error-code
Description The chassis process (chassisd) could not read the EEPROM on the midplane.
Type Error: An error occurred
Severity error
Facility LOG_DAEMON
Action Contact your technical support representative.
CHASSISD_CB_RE_ONLINE_BP_IGNORED
System Log Message Unable to take fru-name fru-slot offline because paired Routing Engine is online
Description The online/offline button for the indicated control board was pressed, but the chassis
process (chassisd) ignored the request. The control board for M40e and M160 routers
is the Miscellaneous Control Subsystem (MCS). The control board for M320, T320, and
T640 routing platforms is the Control Board (CB).
Copyright © 2010, Juniper Networks, Inc.136
Junos 10.3 System Log Messages Reference
To Next Page
Loading...
Need help?
General
