Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 - Page 215

Facility LOG_DAEMON
Action Contact your technical support representative.
CHASSISD_FCHIP_VERSION_ERROR
System Log Message F chip fchip-id: part number (part-number) and version (version) were invalid
Description The indicated part number and version detected for the indicated F chip were not valid
values.
Type Error: An error occurred
Severity error
Facility LOG_DAEMON
CHASSISD_FEB_REVERSION
System Log Message Reversion from FEB fru-slot to FEB slot
Description The chassis daemon (chassisd) reverted to the indicated FEB from the specified FEB.
Type Event: This message reports an event, not an error
Severity error
Facility LOG_DAEMON
CHASSISD_FEB_SWITCHOVER
System Log Message Switchover from FEB fru-slot to FEB slot
Description The chassis daemon (chassisd) switched to the indicated FEB from the specified FEB.
Type Event: This message reports an event, not an error
Severity error
Facility LOG_DAEMON
CHASSISD_FHSR_READ_REG_ERROR
System Log Message Fchip: fhsr_read() failed at address address
Description The high-speed receiver (HSR) read routine failed at the indicated address on an F-chip
register.
Type Error: An error occurred
Severity error
Facility LOG_DAEMON
Action Contact your technical support representative.
151Copyright © 2010, Juniper Networks, Inc.
Chapter 18: CHASSISD System Log Messages