KMD_PM_DYNAMIC_SA_INSTALL_FAILED
System Log Message Unable to install dynamic SA for tunnel tunnel-name
Description Installation of a dynamic security association (SA) failed for the indicated tunnel during
Internet Key Exchange (IKE) Phase 2.
Type Error: An error occurred
Severity error
Facility LOG_AUTH
KMD_PM_ENCRYPTION_INVALID
System Log Message Invalid encryption algorithm negotiated in transform transform-id for use by ESP in tunnel
tunnel-name
Description During Internet Key Exchange (IKE) Phase 2 negotiation of the indicated transform, an
encryption algorithm was chosen to be used by the Encapsulating Security Payload (ESP)
protocol for the indicated tunnel. The algorithm is not a valid value, so the associated
security association (SA) was not installed to the data path.
Type Error: An error occurred
Severity error
Facility LOG_AUTH
KMD_PM_IKE_SERVER_LOOKUP_FAILED
System Log Message No IKE server to connect Phase-1 to remote-peer
Description The IKE Phase-1 negotiation with indicated remote gateway address failed because there
is no corresponding IKE server running locally.
Type Error: An error occurred
Severity error
Facility LOG_SYSLOG
KMD_PM_IKE_SERVER_NOT_FOUND
System Log Message Failed to connect to remote-address:remote-port as there is no IKE server context available
in instance service-set
Description There is no local IKE server context in the indicated service set, hence failed to send the
SPI delete notification request.
Type Error: An error occurred
Severity error
Facility LOG_SYSLOG
Copyright © 2010, Juniper Networks, Inc.330
Junos 10.3 System Log Messages Reference
To Next Page
Loading...