Description The Internet Key Exchange (IKE) server instance for the indicated service set did not
include an entry for the indicated remote peer (address and port), so the key management
process (kmd) could not send a dead peer detection (DPD) reply.
Type Error: An error occurred
Severity error
Facility LOG_AUTH
KMD_DPD_UNEXPECTED_IKE_STATUS
System Log Message DPD reply to remote peer remote-address:remote-port failed with unexpected status
status for IKE server instance ike-instance
Description A dead peer detection (DPD) reply sent to the indicated remote peer (address and port)
failed and returned the indicated Internet Key Exchange (IKE) status code for the indicated
IKE instance.
Type Error: An error occurred
Severity error
Facility LOG_AUTH
KMD_PM_AUTH_ALGORITHM_INVALID
System Log Message Invalid authentication algorithm auth-algorithm-id negotiated in transform transform-id
for use by protocol-name in tunnel tunnel-name
Description During Internet Key Exchange (IKE) Phase 2 negotiation of the indicated transform, the
indicated authentication algorithm was chosen to be used by the indicated protocol
(Authentication Header [AH] or Encapsulating Security Payload [ESP]) for the indicated
tunnel. The algorithm is not a valid value, so the associated security association (SA)
was not established.
Type Error: An error occurred
Severity error
Facility LOG_AUTH
KMD_PM_DUPLICATE_LIFE_DURATION
System Log Message Duplicate SA life duration value given in Quick Mode notification from
remote-address:remote-port
Description The IKE Quick Mode notification message from the indicated remote gateway and remote
port contains duplicate value for life duration. Hence Quick Mode notification payload is
dropped.
Type Error: An error occurred
Severity error
Facility LOG_SYSLOG
329Copyright © 2010, Juniper Networks, Inc.
Chapter 43: KMD System Log Messages
To Next Page
Loading...
Need help?
General
